| Project 40: Wheel Bearings |
The Pelican site has never had a good wheel bearing replacement article until now. Wayne took special care to document all aspects of wheel bearing replacement, and the principles are applicable to almost any car.
Click here to read the entire article on Project 40! |
|
Porsche 986 Boxster (1997-04) |
| Wheel Bearings |
Wheel bearings are one of the parts that routinely wear out. With the car off the ground, check the wheel for any wobbling or excessive noise. Replace bearings in pairs. Tech Tip: Freeze the bearings prior to installation. The cold temperatures will make them shrink slightly and be easier to press in. They also make a nice snack when served with ice cream.
Manufacturer: SKF or FAG - Porsche OEM Suppliers |
|
Wheel Bearing, Boxster Front/Rear (1997-04) Boxster S Front only (2000-04), Each
Brand: SKF [Photo] | 999-053-041-04-M92 | No Longer Available | |
Wheel Bearing, Boxster Front/Rear (1997-04) Boxster S Front only (2000-04), Each
Brand: FAG [Photo] |  |
| 999-053-041-04-M34 | $40.00 |  |
Rear Wheel Bearing (2 per car, sold individually) Boxster S (2000-04), Each
Brand: FAG | |
| 999-053-054-06-M34 | $56.75 | |
| Rear Wheel Bearing Extractor and Installer Kit |
| If you want to save on a costly repair, replace your own bearing or pull your own hubs with our all in one Porsche kit. Designed to efficiently remove and install hub and wheel bearings, this kit will make the notoriously difficult job of removing rear wheel bearings a breeze. The kit comes with a set of adapters specific to the 911 series, but can also be used on all front and rear wheel drive vehicles with independent suspension. The tool eliminates the need for such drastic measures such as a slide hammer or flame torch to remove the rear wheel bearing. The tool facilitates the installation and removal of the rear bearings, and makes the whole job 1000% easier. |
|
Rear Hub/Bearing Extractor and Installer Kit [Photo] | PEL-TOL-SIRB90-P2 | $379.00 | |
Porsche 987 Boxster (2005-08) |
| Wheel Bearings |
Wheel bearings are one of the parts that routinely wear out. With the car off the ground, check the wheel for any wobbling or excessive noise. Replace bearings in pairs. Tech Tip: Freeze the bearings prior to installation. The cold temperatures will make them shrink slightly and be easier to press in. They also make a nice snack when served with ice cream.
Manufacturer: SKF or FAG - Porsche OEM Suppliers |
|
Wheel Bearing, Front/Rear (4 per car, sold individually), Boxster/Boxster S (2005-08), Each
Brand: FAG | |
| 999-053-054-06-M34 | $56.75 | |
| Rear Wheel Bearing Extractor and Installer Kit |
| If you want to save on a costly repair, replace your own bearing or pull your own hubs with our all in one Porsche kit. Designed to efficiently remove and install hub and wheel bearings, this kit will make the notoriously difficult job of removing rear wheel bearings a breeze. The kit comes with a set of adapters specific to the 911 series, but can also be used on all front and rear wheel drive vehicles with independent suspension. The tool eliminates the need for such drastic measures such as a slide hammer or flame torch to remove the rear wheel bearing. The tool facilitates the installation and removal of the rear bearings, and makes the whole job 1000% easier. |
|
Rear Hub/Bearing Extractor and Installer Kit [Photo] | PEL-TOL-SIRB90-P2 | $379.00 | |
